Sony Cyber-shot DSC-P52 LCD Replacement

ID: 5039

Description: The LCD should be checked if the screen is...

Steps:

1. Open the battery compartment and remove the batteries.
2. Remove all of the visible screws on the outside of the case.
3. There should be three of them that are all easily located.

4. Open the memory card compartment.
5. Remove the screw next to the memory card slot.

6. Pull apart the front and back cover pieces carefully.
7. The front cover should come completely free with little effort.
8. The back cover will still be attached to the circuit board.

9. Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.
10. The circuitry will still be connected to the back case by ribbon cables.

11. Open the case as shown.

12. Unclip the clip holding the ribbon cable in.
13. Other ribbon cables might not have a clips.

14. Pull the ribbon cable out.

15. Unclip the ribbon cable shown the in picture.
16. Some ribbon cables do not have a clip holding them in.

17. Pull the ribbon cable out.

18. Remove 7 Screws to remove plate and expose LCD screen.

19. Remove LCD plate to expose LCD components and ribbon cables

20. Check connection of LCD to cables
21. If cables are intact, disconnect cables and replace LCD with new part

22. Repeat steps in reverse order to reassemble the camera