Nikon Coolpix S210 Circuit Board Cover Replacement

ID: 4992

Description: Remove the circuit board cover so they can...

Steps:

  1. Place thumb on the battery cover panel on the bottom of the device.
  2. Slide the panel to the right away from the camera.
    3. Step image
  3. Slide the orange latch outward towards the corner of the camera.
  4. The battery should pop out.
  5. Remove the battery and reattach the cover.
    6. Step image Step image
  6. After removing the battery, unscrew the four 3.10mm screws on the side opposite the buttons.
    7. Step image
  7. Unscrew the three 4.05mm screws on the bottom of the camera below the lens.
    8. Step image
  8. Unscrew the two 4.05mm screws on the side next to the buttons.
    9. Step image
  9. Gently wedge the flat end of the spudger between the back case and the wrist-strap mount.
  10. The wrist-strap mount is the thin metal piece on the side of the camera. Your camera may have the wrist-strap attached, but you will not need to remove it to continue.
  11. Carefully pry the back case away from the camera and then gently lift it off.
    12. Step image Step image
  12. Having removed the back case, the LCD screen should be sitting loosely on the camera, attached only by a wide ribbon and a narrow ribbon.
  13. The ribbons are connected to and held in place by small plastic latches.
  14. To remove the wide ribbon, gently pry the spudger underneath the black plastic latch where the ribbon connects and lift up. The ribbon should slide out easily.
  15. Repeat the same process with the smaller ribbon, this time looking for a light blue latch.
    16. Step image Step image Step image
  16. Gently remove the LCD screen.
    17. Step image
  17. After removing the LCD screen, unscrew the four 3.8mm screws that hold down the metal plate
  18. Unscrew the 2.5mm screw next to the wrist-strap mount.
    19. Step image
  19. Position the camera with the lens facing down and the shutter button facing you.
  20. Lift the metal plate away from the camera without removing it fully. There is a ribbon attaching the edge of the plate to the camera.
  21. The ribbon is being held in place by a black latch.
  22. Carefully pry the spudger under the black latch and lift gently upward. The ribbon will slide out easily.
  23. With the ribbon unlatched, the entire metal plate should now be detached.
    24. Step image Step image
Back