Canon PowerShot SD1100 IS Function Buttons Replacement

ID: 4952

Description: This guide should be used if our guide, ", does...

Steps:

  1. Remove wrist strap and battery.
    2. Step image Step image
  2. Remove 2 screws from each side of the camera (4 total, 0.102 in).
  3. Remove 2 screws from the bottom on the camera (0.138 in).
  4. Do not mix the 4 side screws with the 2 bottoms ones; they are different sizes.
    5. Step image Step image Step image
  5. Gently pull off the front cover.
  6. The plate on the side should come off.
  7. Gently pull off the back cover.
    8. Step image Step image Step image
  8. The cases should now be removed.
    9. Step image
  9. Use the spudger to disconnect the black tab.
    10. Step image
  10. Gently pull off the shutter button assembly.
    11. Step image
  11. Use the tweezers to disconnect the microphone cable.
    12. Step image
  12. The shutter button assembly should now be removed.
    13. Step image
  13. With the spudger, flip up the black tab on the main ribbon.
    14. Step image
  14. Gently pull straight out on the ribbon to disconnect it from the logic board.
    15. Step image Step image
  15. By hand, gently unfold the function button board and lift it off the frame.
    16. Step image
  16. Congratulations! The function button board can now be replaced.
    17. Step image
Back