iBook G4 12" 800 MHz-1.2 GHz Keyboard Replacement

ID: 155

Description: Replacing this keyboard is easy and takes only...

Steps:

  1. Use a coin to rotate the battery locking screw 90 degrees clockwise.
    2. Step image
  2. Lift the battery out of the computer.
    3. Step image
  3. Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.
  4. If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again.
  5. Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.
    6. Step image
  6. If the computer has an AirPort card installed, follow the next three steps to remove it.
  7. Push the wire clasp away from the AirPort card and toward the display, then rotate up to free it from the RAM shield.
    8. Step image
  8. Grasp the clear plastic tab on the AirPort card and pull toward the display.
    9. Step image
  9. Hold the AirPort card in one hand and use your other hand to remove the antenna cable.
    10. Step image
  10. Remove the four silver Phillips screws that secure the RAM shield.
    11. Step image
  11. Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.
    12. Step image
  12. Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.
  13. Make sure that you reconnect the keyboard cable before replacing the RAM shield.
    14. Step image
Back